$68.60$62.36 Ex. GST
All Mitutoyo gage blocks meet or exceed all known specifications. The flatness, parallelism and surface finish necessary to achieve the required accuracies are the same as or better than government requirements.
STEEL – High-carbon, high-chrome steel is employed to sufficiently satisfy a variety of material characteristics required for gage blocks. A high degree of hardness, obtained by our heat treatment technology, as well as methodically repeated heat treatment, have successfully reduced deterioration change over time.
CERA (Ceramic) – CERA blocks, made of ceramic materials with superior surface quality, were developed by Mitutoyo’s ultra-precision machining techniques and solve problems commonly associated with steel gage blocks.
Each gage block is supplied with a Certificate of Inspection
A Certificate of Inspection is furnished with all Mitutoyo gage blocks with a serial number on the case and an identification number on each block.
The deviation of each block is registered. For this inspection, each gage block is measured relative to the upper level master using a gage block comparator.
Grade K gage blocks are manufactured by absolute measurement using an interferometer.
The gage block set and discrete gage block are supplied with a Certificate of Calibration.
The Certificate of Calibration specifies the deviation from the nominal length. (Comparative measurement, however, is performed for all square gage blocks.)
| Weight | 0.0000 kg |
|---|---|
| barcode | |
| Additional Information |
